Cup Holder Armrest Installation

Step-by-step guide to fitting your Surf Syndicate Cup Holder Armrest. About 10 minutes, no special tools needed.

Loosening nuts on the underside of the mounting bracket
Step 1

UNDO BOLTS

Loosen nuts on the underside of the mounting bracket so they slide in the 3 slots.

Mounting plate slid outwards to full extension
Step 2

ADJUST MOUNTING PLATE

Slide the bracket outwards to full extension.

Armrest mounted on the top of the door card
Step 3

TEST FIT ARMREST

Mount the armrest onto the top of the door card. The bracket should slot into the space between the window and the doorcard. Slide it to your preferred position.

Tightening the nuts to lock the armrest in place
Step 4

TIGHTEN NUTS

Tighten the nuts back up for a secure fit.

SURF badges installed in the recessed slot
Step 5

INSTALL BADGES

The "SURF" badges sit inside the cup holder, under the silicon sleeve. Remove the backing tape and install them on both sides in the recessed slot — or leave them off for a more minimal look.

Need a hand?

Email campbell@surfsyndicate.co.nz or DM @surfsyndicate_ and we'll get back to you within a couple of hours.

While you're here — if you're shopping for another Surf or know someone who is, we wrote the free 18-page Buyer's Bible on the Hilux Surf and 4Runner. Every generation, the traps, the 15-minute driveway inspection you can run before you hand over money.

Get the Buyer's Bible →